Skip to content

Body fat calculator

Your body fat percentage from a tape measure, by the US Navy or the US Army method.

Method
Units
Sex
cm
kg
cm

Just below the Adam's apple

cm
cm

At the widest point

Weight is optional for the Navy method; it splits the result into fat and lean mass.

Body Fat Calculator by Utility Empire

What the number means

Body fat percentage is the share of your weight that is fat. Unlike BMI, it separates fat from muscle, so two people with the same weight and height can get very different results. Tape methods estimate it from body shape: more fat around the middle relative to your frame means a higher number. It is an estimate, typically within 3 to 4 percentage points of a lab measurement, and a poorly placed tape can move it more than that.

The bands in the result come from the American Council on Exercise chart. They describe ranges; they aren't medical cut-offs.

The formulas

US Navy / Department of Defense method (all measurements in inches):

  • Men: 86.010 × log₁₀(waist − neck) − 70.041 × log₁₀(height) + 36.76
  • Women: 163.205 × log₁₀(waist + hip − neck) − 97.684 × log₁₀(height) − 78.387

US Army one-site method (weight in pounds, waist at the navel in inches):

  • Men: −26.97 − 0.12 × weight + 1.99 × waist
  • Women: −9.15 − 0.015 × weight + 1.27 × waist

Metric inputs are converted exactly (1 in = 2.54 cm, 1 lb = 0.45359237 kg) before the formula runs.

Sources:

  • Hodgdon JA, Friedl K. "Development of the DoD Body Composition Estimation Equations." Naval Health Research Center, Technical Document 99-2B (1999).
  • US Army. Army Directive 2023-11 and ALARACT 046-2023, "Army Body Fat Assessment for the Army Body Composition Program" (June 2023), table B-5.
  • Taylor KM, Castellani MP, Bartlett PM, et al. "Development and cross-validation of a circumference-based predictive equation to estimate body fat in an active population." Obes Sci Pract 2024;10(2):e747.
  • American Council on Exercise. "Percent Body Fat Norms for Men and Women."

Worked examples

  • Army method, man, 210 lb, waist 35 in: −26.97 − 25.2 + 69.65 = 17.48, which the Army rounds to 17%. (This is the Army's own example.)
  • Army method, woman, 165 lb, waist 30 in: −9.15 − 2.475 + 38.1 = 26.475, rounded to 26%. (Also the Army's example.)
  • Navy method, man, 5 ft 10 in, neck 15 in, waist 34 in: 86.010 × log₁₀(19) − 70.041 × log₁₀(70) + 36.76 = 17.5%.

Honest limits

The equations were built on military personnel, mostly young and fit. They are less reliable for older adults, very muscular people, and people with obesity, and they aren't for children or during pregnancy. For a precise number, a DXA scan is the usual reference.

Guides

Frequently asked questions

How accurate is the tape measure method?

Reasonably, for a free method. In the studies behind these equations, tape estimates landed within about 3 to 4 percentage points of lab methods (underwater weighing, DXA) for most people. A careless measurement can move the result by more than that, so measure twice and take the average.

Navy or Army method: which should I use?

The Navy method uses more measurements (neck, waist and, for women, hips) plus height, and it is the one most people mean by "tape test". The Army method needs only your waist at the navel and your weight. The US Army switched to it in 2023 because it predicted lab results about as well and is quicker. If you are measuring for the Army, use the Army method.

Where exactly do I measure?

Neck: just below the Adam's apple, with the tape sloping slightly down at the front. Waist: men and the Army method at the navel; women on the Navy method at the narrowest point. Hips: around the widest part of the buttocks. Stand relaxed, breathe out normally, and keep the tape snug but not pressing into the skin.

What is a healthy body fat percentage?

There is no single official cut-off. The American Council on Exercise chart is widely used: for men about 14 to 24% is the fitness to average range, and for women about 21 to 31%. Very low body fat (below about 6% for men and 14% for women) is the essential fat the body needs to function, and isn't a target.

Why is my result different from my smart scale?

Smart scales use bioelectrical impedance, which changes with how much water you are carrying, so the number can swing by several percent in a day. Tape methods use body shape instead. Both are estimates; pick one method and track the trend.